Sump Pump Instructions
SUMP PUMP INSTRUCTIONS
1. TURN OFF ALL PUMPS.
2. TURN JANDY(GRAY VALVE) WHERE OFF IS TOWARD THE PUMP BASKET. YOU MAY NEED TO JUMP STOP ON THE VALVE.
3. OPEN BALL VALVE TO THE SIDE.
4. SET FILTER ON WASTE.
5. TURN THE POOL PUMP ON.
6. STAY WITH THE SYSTEM. IF WATER DOES NOT START FLOWING IN THE POT ON THE PUMP, TURN OFF THE PUMP AND CALL SWIMMING POOLS OF TUPELO.
7. AFTER WATER STOPS FLOWING TURN OFF THE PUMP.
8. CLOSE THE BALL VALVE.
9. TURN JANDY VALVE BACK TO WHERE OFF IS AWAY FROM THE PUMP POT.
10. TURN FILTER TO RINSE. TURN THE PUMP BACK ON FOR ABOUT 30 SECONDS. THEN TURN THE PUMP OFF AND TURN THE FILTER BACK TO THE FILTER POSITION.
11. TURN THE POOL PUMP BACK ON.
INSTRUCTIONS FOR VACUUMING AN INGROUND POOL
1. ATTACH VACUUM HEAD TO THE POLE.
2. ATTACH VACUUM HOSE TO THE VACUUM HEAD.
3. SUBMERGE THE HEAD & HOSE INTO THE WATER.
4. PUSH AIR OUT OF THE HOSE BY HOLDING THE VACUUM HEAD IN FRONT OF THE RETURN JET WHILE THE POOL IS RUNNING.
5. TURN OFF POOL.
6. TURN OFF THE MAIN DRAIN VALVE AND IF YOU HAVE TWO SKIMMERS, TURN OFF THE ONE YOU ARE NOT USING.
7. POSITION A VACUUM PLATE IN THE SKIMMER AND ATTACH THE HOSE TO THE PLATE OR YOU CAN ATTACH THE VACUUM HOSE TO THE SUCTION HOLE FOUND IN THE BOTTOM OF THE SKIMMER.
8. TURN POOL BACK ON WITH THE FILTER ON THE FILTER POSITION. BEGIN VACUUMING.(NOTE: IF YOU HAVE FLOCKED THE POOL OR VACUUMING ALGAE YOU MAY NEED TO PUT FILTER ON THE WASTE/DRAIN POSITION.THIS PUMPS WATER AND WASTE DIRECTLY OUT OF THE POOL FROM YOUR WASTE LINE. BE SURE YOU ALWAYS TURN THE PUMP OFF BEFORE CHANGING THE SETTINGS.) YOU MAY NEED TO BACKWASH THE FILTER AND CLEAN THE BASKETS OUT WHILE VACUUMING IF YOU LOSE SUCTION THEY MAY GET FULL OF DIRT AND DEBRIS.